Why is my AcuRite weather station stopped working?
Hard Reset: Bring both the sensor and display unit together and power down by removing all batteries from each and/or removing the power cord. Change the A-B-C switch on both units to a new, matching channel then press and hold the reset button for 20 seconds if applicable.
Why is my AcuRite not working?
Bring both the sensor and display unit together and power down by removing all batteries from each and/or removing the power cord. Change A-B-C switch on both units to a new matching A-B-C channel then press and hold the reset button on the display for 20 seconds. Reinstall the batteries in the outdoor sensor.
Where is the reset button on the AcuRite weather station?
First, locate the reset button inside the battery compartment of the display unit. Press and release this button to factory reset the weather station.
How do I reset my AcuRite thermometer?
Hard Reset:
- Bring both the sensor and display unit together and power down by removing all batteries from each and/or removing the power cord.
- Change the A-B-C switch on both units to a new, matching channel then press and hold the reset button on the display for 20 seconds if applicable.
Why is my AcuRite blinking?
Flashing of the outdoor temperature is generally an indication of wireless interference. 1. Bring both the sensor and display unit indoors and remove at least one battery from each. Reinstall the battery in the display unit.
How do I calibrate my AcuRite weather station?
Calibration can improve accuracy when sensor placement or environmental factors impact your data accuracy. 1. To access calibration mode, press AND HOLD the “▲”, “Set”, and “▼” buttons (located on the back of the display unit) for at least 5 seconds.
How do I reset my clock on AcuRite?
Reset the unit by pressing the reset button, located in the battery compartment. This resets the alarm to the original factory settings. Time and date will need to be entered after a reset. Verify the clock is placed out of direct sunlight and away from any heat sources or vents (see page 6).
How do I calibrate my Acurite weather station?
What to do if your acurite Iris unit is showing incorrect temperature?
If your AcuRite Iris™ (5-in-1) Display unit or My AcuRite® account is showing the incorrect or inaccurate outdoor temperature or outdoor humidity readings from your AcuRite Iris™ (5-in-1) Weather Station, please review the troubleshooting suggestions below. These steps may also be performed if you are seeing the following error codes:
How to contact acurite weather monitoring for support?
Agents are available for live chat Monday through Friday from 7:30 am to 5:00 pm CT, by clicking the Help button in the bottom right side of the website page. Visit our Support Site for general support, frequently asked questions, to submit a request, and more.
How tall should the acurite Iris sensor be?
Make sure the AcuRite Iris™ (5-in-1) sensor is mounted at least 5 feet off of the ground. Confirm the display is showing 4 full bars of signal strength.
Where are the screws on the acurite Iris?
Open your AcuRite Iris™ (5-in-1) outdoor sensor by removing the (4) four screws from the bottom. The screws toward the center of the sensor are for Rain Gauge calibration only. Do not adjust these screws.