Are waterproof tail lights submersible?
Expert Reply: A submersible tail light can let water in, there is usually a hole at a low point so the water can drain out. A waterproof light should be sealed to keep out water. For either type, you would also want to seal out water where the tail light wiring splices into the trailer wiring.
How do submersible trailer lights work?
A submersible light allows water into the unit when submerged. The bulb and socket are protected by an air pocket formed by the “Bell-jar principle” which permits only a certain amount of water to enter, not allowing water to come in contact with the bulb.
Are LED tail lights submersible?
When selecting an LED light, if the description states it is waterproof or submersible then the light can be submersed in water. The item you selected, Waterproof, Under 80 Inch LED Trailer Light Kit with 25 Foot Wiring Harness, part # TLL9RK, has encased LED diodes.
What are submersible trailer lights?
These submersible trailer lights provide all-weather protection for launching watercraft or off-road water crossings. These submersible trailer lights function as a tail lights, stop and turn signals.
Does waterproof mean submersible?
A submersible tail light can let water in, there is usually a hole at a low point so the water can drain out. A waterproof light should be sealed to keep out water.
Do you need submersible lights for boat trailer?
As a boat owner, your boat trailer lights need to be waterproof and submersible, as you will be backing your trailer into the water whenever you put your boat into the water or take it out. As with any marine products, a set of trailer lights need to be resistant to corrosion.
Should I unplug trailer lights when launching boat?
Today, many new trailers use LED lights (light-emitting diode) that burn cooler, are sealed, and don’t need to be unplugged. So if incandescent, then unplug the lights – but remember to plug them back in when leaving the boat ramp. If LED keep them plugged in.
What does submersible lights mean?
If a taillight is considered submersible that means that the internal circuits are waterproof and would be protected for if you were to back the trailer into water like when launching a boat. Lights that aren’t waterproof or submersible will still work just fine on a trailer driven through rain.
What is level 7 water?
For example, a rating of IPX7 would offer level 7 water protection our of 9 levels and is defined as can be submerged up to 1 meter in water for 30 minutes.
What is the highest level of waterproofing?
SO, SHOULD I JUST GO FOR THE HIGHEST RATING?
| Waterproof Rating (mm) | Level of Water Resistance |
|---|---|
| 6,000-10,000mm | Some resistance |
| 11,000-15,000mm | Normal resistance |
| 16,000-20,000mm | High resistance |
| 20,000mm + | Highest resistance |
How many lights does my trailer need?
Lighting. A trailer must have at least one red light attached to the back that lights up when the brakes are applied. Trailers also are required to have rear lights, parking lights, turn-signal lights, hazard lights and stop lamps. All lights must be visible to the human eye from 500 feet away at night.